Process flow of crosscutting unit:

The coil carriage will transport the aluminum coil to the main and pay uncoiler, start the main and pay uncoiler to the middle oil cylinder, and tighten the aluminum coil; Start the guide plate lifting hydraulic cylinder, lift the guide plate, start the guide plate elastic hydraulic cylinder, open the aluminum coil; The main engine and the uncoiler move the aluminum coil to rotate, so that the aluminum plate successfully passes through the guide plate protruding channel and enters the pinch roll equipment that has been started. The friction force is used to pass the aluminum plate successively through the straightening roll equipment, the cleaning equipment (cleaning the oil aluminum powder on both sides of the aluminum plate, etc.), the straightening machine (straightening machine), the rotating flat shear (cutting the length), the belt conveyor (viewing the aluminum plate) and enters the palletizer table. The stacking plate is measured, and the aluminum plate is transported out by the stacking cart.

Cross shear unit usage description:

The unit is a continuous production line, which is used to cut the rolled coils of aluminum and aluminum alloy into plates of fixed length and arrange the stacks.

Main features of transverse shear unit:

(1) The shearing method is rotary flying shear

Unit transmission gear method, the selection of special alloy steel materials, after heat treatment on the imported grinding machine grinding teeth, the accuracy can reach the new specification 6 or more (old specification 1), can eliminate the impact sound during shearing.

The main drive motor is selected transverse shear communication servo motor. It is controlled by a specially planned integrated module, and the measuring accuracy can reach ±0.5mm.

(2) The straightening equipment uses six rolls

The six-fold straightener has good rigidity and high precision.

The center roll is isolated, and the traces on the side of the back-up roll cannot be repeatedly printed on the surface of the plate.

(3) No looping control is selected to reduce scratches, ensure quality and save civil construction costs.

(4) The pileboard is selected as an air cushion pileboard, which can be completed without scratches and regular pileboard.